Mistmaker, "usvatin"

Product 100194. Mistmaker, "usvat" slowly replacing multicolored LEDs with AC adapter. Embedded in water, the device "makes a cold mist". The liquid should be around the sensor at a width of at least 10 cm around the edge of the sensor to ensure sufficient cooling. In depth, water can be in the container as much as you want, but about 10cm from the top of the sensor is often a good height. If there is too little water above, the vibrator will splash along the table, the vibrator will turn off when the surface of the water falls below the probe head above it. Humidifies your environment, operating frequency of about 40 kHz. Automatic stop when there is not enough water above the sensor. NOTE! The vibrator is destroyed if it is used incorrectly in the air, for example by shortening the end of the oscillator sensor part to the frame, the warranty will not be replaced if the sensor is detected when opened. Usage eg. witch-akan padan in the soups, with plants, in terrariums etc ...

Kuvassa kulhossa oleva usvatin toiminnassa.